A、A.network 172.26.168.0 area 478
B、B.network 172.26.0.0
C、C.network 172.26.168.128 0.0.0.127
D、D.network 172.26.168.128 area 478
更多“The EIGRP configuration in the Glencoe router uses a single network statement.From the output shown in the graph would advertise these networks in EIGRP?（）”相关的问题
A、EIGRP works on F0/0 and S0/0/0 without further configuration B、EIGRP works with the addition of one command: a no shutdown command in EIGRP router configuration modE C、EIGRP works with the addition of one command: an eigrp router - id command in EIGRP router configurat ion modE D、EIGRP for IPv6 needs at least two more configuration commands before it works on R1
A、Verify that the EIGRP hello and hold timers match exactly. B、Verify that EIGRP broadcast packets are not being dropped between the two routers with the show ip EIGRP peer command. C、Verify that EIGRP broadcast packets are not being dropped between the two routers with the show ip EIGRP traffic command. D、Verify that EIGRP is enabled for the appropriate networks on the local and neighboring router.
A、An EIGRP route will go active if there are no successors or feasible successors in the EIGRP topology table. B、An EIGRP route will go passive if there are no successors in the EIGRP topology table. C、DUAL will trigger an EIGRP query process while placing the flapping routes in the holddown state. D、A feasible successor in the EIGRP topology table can become the successor only after all the query requests have been replied to. E、The stuck in active state is caused when the wait for the query replies have timed out. F、EIGRP queries are sent during the loading state in the EIGRP neighbor establishment process.
A、TK1#show ip eigrp adjacency B、TK1#show ip eigrp topology C、TK1#show ip eigrp interfaces D、TK1#show ip eigrp neighbors E、None of the above
A、Router# show ip eigrp adjacency B、Router# show ip eigrp topology C、Router# show ip eigrp interfaces D、Router# show ip eigrp neighbors
A、Router# show ip eigrp adjacency B、Router# show ip eigrp topology C、Router# show ip eigrp interfaces D、Router# show ip eigrp neighbors
A、Router# show ip eigrp adjacency B、Router# show ip eigrp topology C、Router# show ip eigrp interfaces D、Router# show ip eigrp neighbors
A、The no auto - summary command needs to be added under router eigrp 1 B、The subnets keyword was not included in the redistribute command under router ospf 1 C、The metric specified for the redistributed EIGRP routes is too large; m aking the EIGRP routes unreachable by router A D、The default - information originate command needs to be added under router ospf 1 E、The administrative distance of either OSPF or EIGRP must be changed so that EIGRP has a higher administrative distanc e than OSPF
A、The show ip eigrp neighbors command on R1 lists the revised Hello timer B、The show ip eigrp interfaces command on R1 lists the revised Hello timer C、The R1 - R2 neighborship fails due to Hello timer mismatcH D、The show ip eigrp interfaces detail command on R1 lists the revised Hello timer
A、Under t he router eigrp mode add redistribute igrp 123 subnets B、Under the router igrp mode add redistribute eigrp 123 C、None, EIGRP and IGRP are automatically redistributed in this instance. D、Under the router eigrp mode add redistribute igrp 123
客服
TOP
查看正确答案
