搜题

【单选题】

The cable lifter, mooring drum and warp end of a split windlass may be separately engaged or disengaged means of a （）

A、dog clutch

B、Pair of gears

C、worm gear

D、turning gear

查看正确答案

更多“The cable lifter, mooring drum and warp end of a split windlass may be separately engaged or disengaged means of a （）”相关的问题

第1题

[] （） unit is mounted so as to raise and lower the cable from the spurling pipe, which is at the top and center of the chain or cable locker.

A、A.The cable lifter B、B.The hoisting motor C、C.The topping wire D、D.The life-raft

点击查看答案

第2题

[单选题] （） belongs to the cargo handling equipment.

A、cargo winch B、chain lifter C、cable stopper D、windlass

点击查看答案

第3题

[单选题] Anchor capstans are used in some installation where the cable lifter rotates about a （）.

A、horizontal axis B、crankshaft C、vertical axis D、camshaft

点击查看答案

第4题

[] Anchor（） are used in some installations where the cable lifter rotates about a vertical axis.

A、A.windlasses B、B.drums C、C.capstans D、D.warp ends

点击查看答案

第5题

[单选题] The rotating unit of a spilt windlass consists of a（） with shaped snugs to grip the anchor cablea mooring drum for paying out or letting go of mooring wires and warp end for warping duties.

A、cranes B、mooring barrel C、capstans D、cable lifter

点击查看答案

第6题

[单选题] Most anchor handling equipment incorporates （） for mooring purposes.

A、cable lifters B、spur wheels C、bollard D、warpends

点击查看答案

第7题

[单选题] When cabling a rack, which of the following is BEST practice?（）

A、Use rack specific cabling hardware B、Let cables hang loosely behind the servers C、Channel all power cables down the sides, and all network cables down the center D、Keep cables close to the front of the rack for better access

点击查看答案

第8题

[单选题] When testing a CAT5 cable, the technician notices that pin A is open. However, the cable stillworks fine. Which of the following describes how this is possible?（）

A、The cable was tested for 100Base-TX. B、The cable is a 1000BaseT cable. C、The switch uses link aggregation, D、The switch was setup to use MDIX

点击查看答案

第9题

[] Where is the TX reference point? （）

A、A. Where the jumper cable is connected to the output of the TX. B、B. Where the jumper cable is connected to the RBS. C、C. Where the jumper cable is connected to the output of the combiner. D、D. Where the jumper cable is connected to the antenna. E、E. Immediately outside the antenna.

点击查看答案

账号：登录

TOP

请使用微信扫码支付

订单号：
遇到问题请联系在线客服