A、selection of landmarks
B、character of sea bottom
C、strength of current and wind force
D、radius of ship swing to wind or tide
更多“For determining the amount of chains used in anchoring operation,which one of the following factors wouldn’t be considered?（）.”相关的问题
A、determine the need for filter cleaning B、measure any change in oil viscosity C、prevent damage to the filter D、determine the need for batch filtration
A、Oracle uses statistical relevance to determine when an adaptive threshold has been breached for the metric. B、The statistics for the metric values observed over the baseline time period are not examined to determine threshold values. C、Oracle determines when an adaptive threshold has been breached based on the maximum value captured by the baseline. D、The total concurrent number of threshold violations, which must occur before an alert is raised for the metric, has been set to zero.
A、determine types of protocols to be supported B、determine the environment in which the router will be used C、select the number of WAN ports required D、select the number of LAN ports required
A、End hosts determine the path MTU for IPv6. B、End hosts determine the path MTU for IPv4. C、Packet fragmentation occurs at intermediate nodes for IPv4. D、Packet fragmentation occurs at intermediate nodes for IPv6.
A、Each fiber has half of its SONET capacity reserved for protection. B、Two fibers in the span carry working traffic, while the other two fibers in the span are reserved for protection. C、The signal is sent simultaneously in both directions around the ring. The receiver determines which fiber to listen to based on signal quality. D、The signal is sent simultaneously in both directions around the ring. The transmitter determines which fiber has the working bit set for the receiver to acknowledge.
A、visual inspection for dirt accumulation B、high megger readings C、low operating temperature D、the time period since the last cleaning
A、it is not used in multicast B、it determines the virtual address group for a multicast destination C、it dynamically registers individual hosts in a multicast group on a specific LAN D、it is used on WAN connections to determine the maximum bandwidth of a connection E、it determines whether Bidirectional PIM or PIM sparse mode will be used for a multicast flow
A、 The resumable setting on the initiating session determines the resumable conditions for the entire distributed transaction. B、 The resumable setting for the initiating instance determines the resumable conditions for the entire distributed transaction. C、 The resumable setting on the initiating session controls only that part of the transaction that occurs within the local instance； remote resumable settings determine the behavior of the distributed parts of the transaction. D、 None of the above.
客服
TOP
查看正确答案
