A、A.The shaft
B、B.The mechanical
C、C.The electric
D、D.The indicated
更多“（） power is the power developed within the cylinder and can be measured by an engine indicator.”相关的问题
A、The voltage selector switch on the power supply is set incorrectly. B、The 3.3v power line is connected to the wrong input on the motherboard. C、The new power supply voltage rating is too high. D、The 12v power cord is installed incorrectly.
A、The LCD monitor’s power inverter does not function properly. B、The operating system’s power settings prevent the battery from charging. C、The battery is not compatible with the laptop. D、The internal power connection on the motherboard is faulty. E、The power adapter is not working.
A、There is a fire hazard potential if a power outage occurs. B、The last system plugged into the UPS will not be provided any power. C、The UPS will draw more power from the circuit to compensate. D、The runtime of the UPS will be insufficient if a power outage occurs.
A、Continue plugging into the central UPS, but put the UPS on bypass to avoid load problems. B、Plug the servers directly into the power that is not on the UPS. C、Add stand alone UPSs for new servers not wired off the central UPS. D、Continue plugging into the central UPS because the actual load supported is actually higher than stated
A、The hscroot user password. B、The CE password. C、The HMC password. D、The ASM admin password.
A、The UPS is overcharged. B、Incorrect wattage on the power supply. C、The UPS battery is not charged. D、The UPS is in power management mode.
A、The Power 550 is licensed for three LPARs only. B、There is not enough memory to meet the minimum dedicated memory requirement for the fourth LPAR. A faulty memory DIMM is detected in the POWER5 550. C、There is not enough memory to meet the minimum dedicated memory requirement for the fourth LPAR. The HMC reserves some memory toperform logical partition tasks. D、There is not enough memory to meet the minimum dedicated memory requirement for the fourth LPAR. The hypervisor reserves some memory to perform logical partition tasks.
A、the sum of the powers used in each load (resistor) B、divided by the number of loads C、always less than the power used in the smallest load D、the sum of the powers used in each individual load never more than the power used in the largest load
A、A.An additional switch for the new HMC B、B.Asynchronous adapters on the new HMC C、C.The two 570 servers are directly connected to the new HMC D、D.One 570 is directly connected to the new HMC and the other is directly connected to the existing HMC
客服
TOP
查看正确答案
