A、check oil level in bearing sump
B、check them for leakagec through end seals
C、pump bilges in time
D、check temperature
更多“Which is not the maintenance work for shaft bearings in transmission system?（）”相关的问题
A、A.which is not and has not been B、B.which was not C、C.which was D、D.which is not but will be taken by the salver
A、The loopback interface is down and resolv.conf is configured. B、The loopback is not in /etc/hosts and resolv.conf is configured. C、The loopback interface is down and resolv.conf is not configured. D、The loopback is not in /etc/hosts and resolv.conf is not configured.
A、The memory is not the correct CAS latency. B、The memory is not installed in the correct slot. C、The memory does not have the correct timing. D、The memory is not the correct speed.
A、The memory is failing. B、The CPU is overheating. C、The hard drive is not attached properly. D、The operating system is not installed.
A、The NIC is not on the HCL. B、The driver is incorrect on the server. C、The patch cable has not been seated properly. D、The NIC is not seated properly.
A、A. It is loaded with the FIXED status. B、B. It is loaded with the ACCEPTED status. C、C. It is not loaded with the ENABLED status. D、D.It is not loaded with the ACCEPTED status.
A、A. Hard drive cables are not connected. B、B. BIOS chips are not seated properly. C、C. The power supply is not functioning. D、D. Video card is not seated properly.
A、The drum is faulty. B、The print buffer is full. C、The printer is out of toner. D、The fuser is faulty.
A、DHCP is not functioning. B、WINS needs to be restarted. C、DNS is not functioning. D、LDAP is not functioning.
A、The file server is offline. B、The DNS server is not resolving correctly. C、The DHCP server is not assigning correct IP addresses. D、The domain controller is not responding.
客服
TOP
查看正确答案
