Which two routing interface parameters are supported in OSPF implementations?()
A、retransmit - interval
B、de ad - interval
C、stub area
D、virtual link
E、NSSA area
A、retransmit - interval
B、de ad - interval
C、stub area
D、virtual link
E、NSSA area
A、A. All the routes were redistributed into BGP from an IGP B、B. All the routes were originated by BGP with the network command C、C. All six routes will be installed in the routing table D、D. Four routes will be installed in the routing ta ble E、E. Two routes will be installed in the routing table
A、IGP routes advertised by P routers B、IGP routes advertised by PE routers C、VPN routes advertised by PE routers D、VPN routes advertised by CE routers
A、A. All six routes will be installed in the routing table. B、B. Two routes will be installed in the routing table. C、C. Four routes will be installed in the routing table. D、D. All the routes were redistributed into BGP from an IGP. E、E. All the routes were originated by BGP with the network command.
A、peer with route-reflectors within the cluster B、peer with route-reflectors outside the cluster C、peer with route-reflector-clients within the cluster D、peer with route-reflector-clients outside the cluste
A、FWSM routes traffic between the VLANs. B、FWSM switches traffic between the VLANs. C、Routed mode is often called bump-in-the-wire mode. D、Routed mode firewall deployments are used most often in current designs.
A、A successor route is used by EIGRP to forward traffic to a destination. B、Successor routes are saved in the topology table to be used if the primary route fails. C、Successor routes are flagged as "active" in the routing table. D、A successor route may be backed up by a feasible successor route. E、Successor routes are stored in the neighbor table following the discovery process.
A、A. Static routes are defined at the [edit routing-instances] hierarchy. B、B. Static routes must have a next hop defined. C、C. Static routes remain in the routing table until you remove them or until they become inactive. D、D. Static routes are learned by neighboring devices and added to their routing tables.
A、A. No routes are redistributed because a route cannot be both E1 and E2. B、B. Only OSPF E2 routes in the OSPF 2 domain will be considered for redistribution. C、C. Inside the OSPF 2 domain, any formerly E2 routes will become E1 routes. D、D. Routes permitted by ACL 1 will be redistributed, regardless of whether the routes are E1 or E2 routes.
A、The routing table is populated by the forwarding table. B、Devices running the Junos OS can accommodate multiple routing tables. C、Information learned from routing protocols is stored in the routing table. D、The primary routing table for IPv4 unicast routes is inet.4.