When the movement of engine is no longer required the pilot usually gives the order like this() .
A、Stop engine
B、Nothing to port
C、Finish engines
D、Finished with engines
A、Stop engine
B、Nothing to port
C、Finish engines
D、Finished with engines
A、The movement of all segments to a target tablespace with a higher degree of compression, on a different storage tier, when the source tablespace exceeds TBS PERCENT USED B、Setting the target tablespace to read-only C、The movement of some segments to a target tablespace with a higher degree of compression, on a different storage tier, when the source tablespace exceeds TBS PERCENT USED D、Setting the target tablespace offline E、The movement of some blocks to a target tablespace with a lower degree of compression, on a different storage tier, when the source tablespace exceeds TBS PERCENT USED
A、A.prevent the towboat from sliding when the rudder is moved B、B.prevent the barges from spreading out when backing down C、C.hold the towboat securely to the barges D、D.prevent the sidewise movement of the face barges
A、Horizontal movement of the water toward the land after high tide B、Horizontal movement of the water toward the land after low tide C、Horizontal movement of the water away from the land following high tide D、Horizontal movement of the water away from the land following low tide
A、vertical movement of the water B、horizontal movement of the water C、density changes in the water D、None of the above
A、Their bearing is almost constant,even when the true bearing of the contact changes appreciably B、They always appear on a bearing of 90°from the true bearing of the contact C、The indirect echoes usually appear in shadow sectors D、When plotted,their movements are usually abnormal
A、keep the movement of the davits at the same speed B、keep the davits from slipping when they are in the stowed position C、prevent vibration during lowering of the boat D、support the manropes
A、A.Their bearing is almost constant,even when the true bearing of the contact changes appreciably B、B.They always appear on a bearing of 90°From the true bearing of the contact C、C.The indirect echoes usually appear in shadow sectors D、D.When plotted,their movements are usually abnormal
A、set for maximum torque B、on the purge and vent stroke C、in the neutral position D、rotating backwards