A、transport type all
B、transport output all
C、transport preferred all
D、transport input all
更多“Which commands is necessary to permit SSH or Telnet access to a cisco switch that is otherwiseconfigured for these vty line protocols?（）”相关的问题
A、The submit command exits the GUI. B、The submit command reboots the WX device. C、The submit command saves and writes the configuration to flash. D、The submit command is the same as the commit CLI command.
A、The command is used to establish a static route. B、The default administrative distance is used. C、The command is used to configure the default route. D、The subnet mask for the source address is 255.255.255.0 E、The command is used to establish a stub network
A、it is not a valid NetFlow command. B、it is an SNMP command tha texports1500-byte packets to IPaddress192.168.1.50. C、it is a NetFlov/command that v/ill export 1500-byte packets to IP address192.168.1.50. D、it is a NetFlov/command that allows IP address192.168.1.50 to send traffic to port 1500. E、It is a NetFlov/command that v/ill specify that the NetFlov/collector’s IP address is 192.168.1.50 over UDP port 1500
A、A. It is loaded with the FIXED status. B、B. It is loaded with the ACCEPTED status. C、C. It is not loaded with the ENABLED status. D、D.It is not loaded with the ACCEPTED status.
A、The ip classless command is enabled by default in recent versions of IOS. B、The ip classless command should only be enabled when static routing is being used instead of a routing protocol. C、The ip classless command should be enabled by the network administrator whenever RIPv1 or IGRP is being used. D、The ip classless command should be enabled by the network administrator whenever OSPF, RIPv2, or EIGRP is being used.
客服
TOP
查看正确答案
