UDP Ethernet Communication break between BRP and MP表明MP到什么的网络通信中断()
A、GIU
B、BNET
C、SPCU
D、BCTL
A、GIU
B、BNET
C、SPCU
D、BCTL
A、Ethernet_II B、Ethernet_snap C、Ethernet_sap D、Ethernet_802.2 E、Ethernet_802.3 F、Ethernet_802.5
A、在各端口配置一致的情况下,Ethernet1/0/1 端口为聚合组 Unselected 端口 B、在各端口配置一致的情况下,Ethernet1/0/2 端口为聚合组 Unselected 端口 C、在各端口配置一致的情况下,Ethernet1/0/6 端口为聚合组 Unselected 端口 D、在各端口配置一致的情况下,Ethernet1/0/7 端口为聚合组 Unselected 端口
A、Ethernet Private Line B、Ethernet Wire Service C、Ethernet Relay Service D、Ethernet Multipoint Service E、Ethernet Relay Multipoint Service
A、在各端口配置一致的情况下,Ethernet1/0/1端口为聚合组Unselected端口 B、在各端口配置一致的情况下,SWA在7个端口中随机选择一个端口为聚合组Unselected端口 C、在各端口配置一致的情况下,Ethernet1/0/6端口为聚合组Unselected端口 D、在各端口配置一致的情况下,Ethernet1/0/7端口为聚合组Unselected端口
A、show interface Ethernet 0 B、show controller Ethernet 0 C、show config Ethernet 0 D、show detail Ethernet 0
A、Full-duplex Ethernet consists of a shared cable segment. Half-duplex Ethernet provides a point-to-point link. B、Full-duplex Ethernet uses a loopback circuit to detect collisions. Half-duplex Ethernet uses a jam signal. C、Full-duplex Ethernet can provide higher throughput than can half-duplex Ethernet of the same bandwidth. D、Full-duplex Ethernet uses two wires to send and receive. Half-duplex Ethernet uses one wire to send and receive.