While engine is in operation the piston moves up and down, thus causing the rotation of the ().
A、crankcase
B、slipper
C、cam housing
D、crankshaft
A、crankcase
B、slipper
C、cam housing
D、crankshaft
A、In a two-stroke/cycle engine, the rings run hotter, requiring the end gap to be greater B、Some provision must be made in a two-stroke/cycle engine to keep the rings from binding in the ports C、No gap is required to exist between the ends of the ring when cold in a two-stroke/cycle engine, but a small gap is required in a four-stoke/cycle engine D、The gaps should be staggered on either side of a piston in a two-stroke/cycle engine, while staggering is not necessary in a four-stroke/cycle engine
A、fluctuates with the engine speed to some extent, independent of the engine speed B、keeps constant at all engine speed, dependent on the engine speed to some extent C、keeps constant at all engine speed, independent of the engine speed D、is decided by the engine speed, constant at all engine speed
A、The coolant temperature must be maintained at 180℃ B、The thermostatic bypass valves must be manually opened before the engine is started C、The pressure cap must be removed while the engine is secured D、Electrical power to the heater must be secured before the cooling system is drained
A、bearing pressure in a four-stroke\cycle acting single diesel engine is continually reversed B、bearing pressure in a two-stroke\cycle single acting diesel engine is continually reversed C、the maximum bearing pressure is higher in a single acting two-stroke/cycle diesel engine D、two-stoke/cycle diesel engines require more complicated lubrication piping
A、most critical in a four-stroke cycle diesel engine B、most critical in a two-stroke/cycle diesel engine C、most critical in a four-stroke/cycle diesel engine if it is turbocharged D、of equal importance in a two-stroke/cycle diesel engine as in a four-stroke/cycle diesel engine
A、The tape I/O performed is asynchronous B、The tape buffer is allocated from the System Global Area (SGA) C、The tape buffer is allocated from the Program Global Area (PGA) D、Oracle I/O uses an interrupt mechanism to determine when each I/O completes
A、reduce the fuel feeding of main engine of inner propeller B、reduce the fuel feeding of main engine of outer propeller C、firstly reduce the fuel of main engine of inner propeller, then reduce the fuel feeding of engine of outer propeller D、reduce fuel feeding of two engines at the same time
A、caused by retarded injection timing B、caused by a mechanical defect in one cylinder C、caused by high fuel injection pressures D、normal for these conditions
A、The tape I/O performed is asynchronous B、The tape buffer is allocated from the System Global Area (SGA) C、The tape buffer is allocated from the Program Global Area (PGA) D、Oracle I/O uses an interrupt mechanism to determine when each I/O completes