A、Profile atm 1483 must be applied to the atm major interface.
B、The bulk-config-name used is test atm-pppoe.
C、The bulk-config-name used is test.
D、Atm-pppoe is the atm base profile.
E、Atm-pppoe is the atm level interface description.
更多“With the CLI command profile atm 1483 bulk-config-name test atm-pppoe,which three statements describe its purpose and implementation?（）”相关的问题
A、This command was done on the LNS B、This command was done on the LAC C、The 1 defines the destination number D、The 1 defines the session number
A、The submit command exits the GUI. B、The submit command reboots the WX device. C、The submit command saves and writes the configuration to flash. D、The submit command is the same as the commit CLI command.
A、show clns database B、show isis database detail C、show clns database detail D、show isis database extensive
A、Configure the net system - id command under routerisis and enable IS - IS on each interface with the ip router isis command. B、Configure the net sy stem - id and the network net - id commands under routerisis. C、Configure the network net - id command(s) under routerisis and enable IS - IS on each interface with the ip router isis command. D、Configure the network net - id command(s) and the is - type level -1- 2 command under routerisis. E、Configure the net system - id and the network net - id commands under routerisis and enable ISIS on each interface with the ip router isis command.
A、Use installp -u command with -g to remove the fileset and all dependent software. B、Use installp -c command to commit fileset; use installp command with -g to remove the fileset and all dependent software. C、Use installp -C command to perform cleanup of fileset; use install command with -g to remove the fileset and all dependent software. D、Use installp -a command to apply fileset; use installp command with -g to remove the fileset and all dependent software.
A、Run the dsmod command with the appropriate parameters. B、Run the dsget command with the appropriate parameters. C、Run the dsquery command with the appropriate parameters. D、Run the dsmove command with the appropriate parameters. E、Run the dsrm command with the appropriate parameters. F、Run the find command with the appropriate parameters.
A、A.Third image, and resoting the file with the tar command B、B.Third image, and restoring the file with the dd command C、C.Fourth image, and restoring the file with the restore command D、D.Fourth image followed by the tar command
客服
TOP
查看正确答案
