网卡（Network Interface Card，缩写为NIC）也叫（）。

A、网络连接器

B、网络卡

C、网络接口卡

D、网络适配器

查看正确答案

更多“网卡（Network Interface Card，缩写为NIC）也叫（）。”相关的问题

第1题

[单选题] A network interface port has collision detection and carrier sensing enabled on a shared twisted pair network. From this statement, what is known about the network interface port（）。

A、This is a 10 Mb/s switch port B、This is a 100 Mb/s switch port C、This is an Ethernet port operating at half duplex D、This is an Ethernet port operating at full duplex E、This is a port on a network interface card in a PC

点击查看答案

第2题

[单选题] Your network contains a single Active Directory domain. All servers run Windows Server 2008 R2. A DHCP server is deployed on the network and configured to provide IPv6 prefixes.You need to ensure that when you monitor network traffic,you see the interface identifiers derived from the Extended Unique Identifier (EUI)-64 address.Which command should you run?（）

A、netsh.exe interface ipv6 set global addressmaskreply=disabled B、netsh.exe interface ipv6 set global dhcpmediasense=enabled C、netsh.exe interface ipv6 set global randomizeidentifiers=disabled D、netsh.exe interface ipv6 set privacy state=enabled

点击查看答案

第3题

[单选题] Your network contains a server named Server1 that has the Routing role service installed. Server1 has two network connections. One network connection connects to the internal network. The other network connection connects to the Internet.All network connections connected to the internal network use private IP addresses. You install a Web server named Web1. Web1 hosts a secured Web site that only allows connections over TCP port 8281. Web1 is connected to the internal network.You need to ensure that the secure Web site can be accessed from the Internet.What should you do from the Routing and Remote Access console？（）

A、Configure Routing Information Protocol (RIP), and then activate authentication on the RIP interface. B、Configure Routing Information Protocol (RIP), and then configure the incoming packet protocol settings on the RIP interface. C、Configure Network Address Translation (NAT), and then add a new service to the NAT interface. D、Configure Network Address Translation (NAT), and then enable the Secure Web Server (HTTPS) service on the NAT interface.

点击查看答案

第4题

[多选题] Refer to the exhibit. Which three statements correctly describe Network Device A（）

A、With a network wide mask of 255.255.255.128, each interface does not require an IP address. B、With a network wide mask of 255.255.255.128, each interface does require an IP address on a unique IP subnet. C、With a network wide mask of 255.255.255.0, must be a Layer 2 device for the PCs to communicate with each other. D、With a network wide mask of 255.255.255.0, must be a Layer 3 device for the PCs to communicate with each other. E、With a network wide mask of 255.255.254.0, each interface does not require an IP address.

点击查看答案

第5题

[] In a Bridged 1483 network, which CLI commands are used to baseline an IP interface on ATM 6/1.1 and display recent IP transmit and receive statistics?（）

A、A. clear ip interface atm 6/1.1 show ip interface atm 6/1.1 B、B. baseline atm interface atm 6/1.1 show ip interface atm 6/1.1 C、C. clear ip interface atm 6/1.1 show ip interface atm 6/1.1 delta D、D. baseline atm interface atm 6/1.1 show ip interface atm 6/1.1 delta

点击查看答案

第6题

[] In a Bridged 1483 network, which CLI commands are used to baseline an IP interface on ATM 6/1.1 and display recent IP transmit and receive statistics?（）

点击查看答案

第7题

[单选题] Refer to the exhibit. ROUTE Enterprises has many stub networks in their enterprise network, such as router B and its associated network. EIGRP is to be implemented on router A so that neither the prefix for the S/0/0/0 interface nor the prefixes from router B appear in the routing tables for the router in the enterprise network. Which action will accomplish this goal?（）

A、Declare router B a stub router using the eigrp stub command. B、Use the passive - interface command for interface Serial0/0/0. C、Use a mask with the network command to exclude interface Serial0/0/0. D、Implement a distribute list to exclude the link prefix from the routi ng updates.

点击查看答案

第8题

[单选题] A network administrator creates a layer 3 EtherChannel, bundling four interfaces into channel group 1. On what interface is the IP address configured?（）

A、the port-channel 1 interface B、the highest number member interface C、all member interfaces D、the lowest number member interface

点击查看答案

第9题

[单选题] Your network administrator has asked you to view the real-time interface usage on ge-0/0/0. Which command would be used?（）

A、monitor interface ge-0/0/0 B、traceoptions interface ge-0/0/0 C、debug interface ge-0/0/0 D、monitor usage ge-0/0/0

点击查看答案

账号：登录