What does a Layer 2 switch do if it receives a frame with a destination MAC address that is not found in its MAC address table?（）

A、The frame is dropped.

B、The frame is addressed with a broadcast MAC address and sent out all ports.

C、The frame is sent out all ports except the receiving port.

D、An ARP request is sent out all ports except the receiving port.

E、A destination unreachable message is sent back to the source address.

F、None of the above.

查看正确答案

更多“What does a Layer 2 switch do if it receives a frame with a destination MAC address that is not found in its MAC address table?（）”相关的问题

第1题

[单选题] At which layer of the OSI model does error checking occur with IPv6?（）

A、Layer 2 B、Layer 3 C、Layer 4 D、Layer 7

点击查看答案

第2题

[单选题] Which header or set of headers does CRTP compress？（）

A、Layer 2 B、Layer 3 C、Layer 4 D、Layer 2 and Layer 3 E、Layer 3 and Layer 4

点击查看答案

第3题

[单选题] What layer of the TMN （telecommunications management network） model does CTM fit into？（）

A、Network management layer B、Element management layer C、Business management layer D、Network element layer

点击查看答案

第4题

[] After issuing the show interfaces terse command, you notice that the status of one interface is "up down". What does this indicate?"（）

A、A.Layer 1 on the interface is up but Layer 2 is down. B、B.Layer 2 on the interface is up but Layer 3 has not been configured. C、C.The interface is administratively up but the link status is down. D、D.The interface is up but has been administratively turned off.

点击查看答案

第5题

[多选题] Regarding DHCP (dynamic host configuration protocol), which two of the following choices below are true?（）

A、The DHCP Discover message uses FF-FF-FF-FF-FF as the Layer 2 destination address. B、The DHCP Discover message uses UDP as the transport layer protocol. C、The DHCP Discover message uses a special Layer 2 multicast address as the destination address. D、The DHCP Discover message uses TCP as the transport layer protocol. E、The DHCP Discover message does not use a Layer 2 destination address. F、The DHCP Discover message does not require a transport layer protocol.

点击查看答案

第6题

[] At which layer of the OSI model does the Spanning Tree Protocol （STP） operate at？（）

A、A.Layer 5 B、B.Layer 4 C、C.Layer 3 D、D.Layer 2 E、E.Layer 1

点击查看答案

第7题

[多选题] For what two purposes does the Ethernet protocol use physical addresses? （）

A、to uniquely identify devices at Layer 2 B、to allow communication with devices on a different network C、to differentiate a Layer 2 frame from a Layer 3 packet D、to establish a priority system to determine which device gets to transmit first E、to allow communication between different devices on the same network F、to allow detection of a remote device when its physical address is unknown