AutoQoS takes the interface type and bandwidth into consideration when implementing what three QoS features?()
A、FECN
B、LLQ
C、WRED
D、LFI
E、CRTP
F、CBWFQ
A、FECN
B、LLQ
C、WRED
D、LFI
E、CRTP
F、CBWFQ
A、AutoQoS is supported on Frame Relay multipoint subinterfaces. B、AutoQoS is supported on low-speed ATM PVCs in point-to-point subinterfaces. C、AutoQoS is supported on serial PPP and HDLC interfaces. D、AutoQoS is supported only on Frame Relay main interfaces and not on any subinterface configuration.
A、A.The interface you configured for AutoQoS is set to half-duplex B、B.AutoQoS was configured on only one end of the link C、C.The interface you configured for AutoQoS has no IP address D、D.The interface’s bandwidth is not correctly configured E、E.CEF is not enabled on the interface F、F.You enabled AutoQoS on the interface but forgot to enable globally first
A、in class class-default, replace fair-queue with bandwidth remaining percent 50 B、in class autoqos-transactional-Fa0/1, replace bandwidth remaining percent 40 with bandwidth remaining percent 20 C、in class autoqos-transactional-Fa0/1, replace bandwidth remaining percent 40 with bandwidth remaining percent 30 D、in class autoqos-Bulkl-Fa0/1, replace bandwidth remaining percent 19 with bandwidth remaining percent 25 E、in class autoqos-Scavenger-Fa0/1, replace bandwidth remaining percent 1 with bandwidth remaining percent 10 F、in class autoqos-Signaling-Fa0/1, replace bandwidth remaining percent 4 with bandwidth remaining percent 1
A、AutoQoS can be configured from a different subinterface if the DLCI is already assigned to one subinterface B、Multilink PPP (MLP) over Frame Relay must be manually configured on low speed DLCIs C、for low-speed Frame Relay DLCIs with Frame Relay-to ATM interworking, the AutoQoS cannot be configured if a virtual template is already configured for the DLCI D、AutoQoS can be configured on a Frame Relay DLCI only if a map class is attached to the DLCI
A、provide visibility into the classes of service deployed using system logging and SNMP traps B、determine WAN settings for fragmentation, compression, encapsulation, and Frame Relay-ATM interworking C、enable the AutoQoS VoIP for voice traffic D、generate and deploy MQC-based QoS policies E、profile the traffic with Auto-Discovery
A、 Take an image backup nightly while the server is online. B、 Take an incremental backup while the server is offline. C、 Take a monthly snapshot backup while the server is online. D、 Take a differential backup while the server is online.