If a void occurs in the cargo hold,it is better to()to control the broken stowage.
A、brace it with dunnage
B、cover it with large pieces
C、fill it with small pieces
D、leave it as it is
A、brace it with dunnage
B、cover it with large pieces
C、fill it with small pieces
D、leave it as it is
A、Should knocking occur B、If knocking occur C、Should if knocking occurs D、If occur knocking
A、A.brace it with dunnage B、B.cover it with large pieces C、C.fill it with small pieces D、D.leave it as it is
A、There is a fire hazard potential if a power outage occurs. B、The last system plugged into the UPS will not be provided any power. C、The UPS will draw more power from the circuit to compensate. D、The runtime of the UPS will be insufficient if a power outage occurs.
A、A large change of viscosity occurs with a minor change in temperature B、No change in viscosity occurs with any change in temperature C、Very little change in viscosity occurs with a significant change in temperature D、The viscosity of the oil increases with an increase in temperature
A、fuel will not be properly atomized in the cylinder B、ignition will be delayed due to low ignition temperature C、maximum fuel expansion will occur on the compression stroke D、fuel will ignite before top dead center
A、A.a bulge in the wire where the strain occurred B、B.a decrease in diameter where the strain occurred C、C.a kink in the wire where the strain occurred D、D.no visible effects of an overstrain
A、indicate the ship in distress that the alert has been received B、alert ships in the area of a distress incident that a distress has occurred C、inform other coast station of distress incident D、repeat the distress alert in 5 minutes
A、 Compilation fails because of an error in line 3. B、 Compilation fails because of an error in line 7. C、 Compilation fails because of an error in line 9. D、 If you define D e = new E(), then e.bMethod() invokes the version of bMethod()defined in Line 5. E、 If you define D e = (D)(new E()),then e.bMethod() invokes the version of bMethod() defined in Line 5. F、 If you define D e = (D)(new E()), then e.bMethod() invokes the version of bMethod() defined in Line 9.