A、Data, Frame, Packet, Segment, Bit
B、Data, Frame, Segment, Packet, Bit
C、Data, Packet, Frame, Segment, Bit
D、Data, Packet, Segment, Frame, Bit
E、Data, Segment, Frame, Packet, Bit
F、Data, Segment, Packet, Frame, Bit
更多“A PC on a network segment sends data to another PC on a different segment.Which of the following correctly describe the correct order of how this data will be encapsulated?（）”相关的问题
A、This is a 10 Mb/s switch port B、This is a 100 Mb/s switch port C、This is an Ethernet port operating at half duplex D、This is an Ethernet port operating at full duplex E、This is a port on a network interface card in a PC
A、Remove the BIOS chip on the PC B、Re-flash the BIOS C、Run password cracking software on the users PC D、Set the password clear jumper on the motherboard
A、On router R2, configure a default static route to the 192.168.1.0 network. B、On router R2, configure DNS to resolve the URL assigned to Web Server 2 to the 192.168.1.10 address. C、On router R1, configure NAT to translate an address on the 209.165.100.0/24 network to 192.168.1.10. D、On router R1, configure DHCP to assign a registered IP address on the 209.165.100.0/24 network to Web Server 2.
A、Remove network connections B、Remove the RAM C、Self ground on the computer case D、Disconnect power to PC
A、The data link layer B、The application layer C、The access layer D、The session layer E、The network layer
A、the cause of routing errors. B、the number of switches on the network. C、the number of users on the network. D、where network latency will occur.
A、Any routes learned by R2 from the interface tied to the 172.16.0.0 network will not be advertised to neighbors on the 192.168.2.0 network. B、Only routes learned by R2 from the interface tied to the 172.16.0.0 network will be advertised to neighbors on the 192.168.2.0 network. C、Only the 172.16.0.0 network will be advertised to neighbors on the 192.168.2.0 network. D、All networks, except the 172.16.0.0 network will be advertised to neighbors on the 192.168.2.0 network .
A、Install the Network Monitor driver on Server1. Run Network Monitor on Server2 to capture network traffic. B、Open Network Monitor on Server2 and create a capture filter to enable the capture of all protocols. Run Network Monitor to capture network traffic. C、Install Network Monitor Tools on Server1. Run Network Monitor to capture network traffic. D、Open Network Monitor on Server2 and increase the capture buffer from 1 MB to 20 MB in size. Run Network Monitor to capture network traffic.
客服
TOP
查看正确答案
