A、unit 0
B、unit 1
C、unit 100
D、unit 255
更多“Which logical unit number must be configured on an interface using PPP encapsulation?（）”相关的问题
A、Logical units are similar to VLANs used by other vendors. B、A logical unit is required for transit interfaces. C、Frame Relay encapsulation supports one logical unit. D、Link speed and duplex are configured in the logical unit properties.
A、A.Logical units are used only when a Layer 2 identifier is present such as a VLAN B、B.A logical unit of 0 is required when using a frame-relay DLCI C、C.A logical unit is always required D、D.Logical units are not required unless ATM or 802.1Q VLAN tagging is configured.
A、Software Units B、Replaceable Units C、Logical Units D、Printed Circuit Boards
A、You cannot assign st interfaces to a security zone. B、You cannot apply static NAT on an st interface logical unit. C、st interfaces are optional when configuring a route-based VPN D、A static route can reference the st interface logical unit as the next-hop
A、If the interface is disabled, the logical unit will administratively shutdown. B、If the interface is deactivated, the physical interface will administratively shutdown. C、If the interface is deactivated, the interface configuration is ignored during commit. D、If the interface is disabled, the logical unit configuration is ignored during commit.
A、Units in JUNOS are always required for any interface configured with logical addresses such as IP and IPv6. B、Units in JUNOS are only required when you are configuring sub-interfaces for inter-VLAN routing. C、Unit numbers must match the DLCI or VCI numbers configured on the interface. D、Unit 0 is the only value allowed on interfaces running HDLC, PPP, or for Ethernet interfaces not doing VLAN-tagging.
A、Logical Partition B、Workload Partition C、Dynamic Logical Partition D、Shared Processor Logical Partition
A、Developer unit B、Scanner unit C、Fuser unit D、Laser unit
客服
TOP
查看正确答案
