If the winch should fail while you are hauling in the anchor,what prevents the anchor cable from running out().
A、Chain stopper
B、Devil's claw
C、Hawse ratchet
D、Riding pawl
A、Chain stopper
B、Devil's claw
C、Hawse ratchet
D、Riding pawl
A、excessive loads are placed on the winch B、minimum pull is being exerted by the winch C、automatic operation of the winch is desired D、wire is being retrieved at the maximum rate
A、when the line pull reaches the rated winch capacity B、after the line pull exceeds the rated winch capacity C、after a short build-up of torque D、immediately
A、when the line pull reaches the rated winch capacity B、after the line pull exceeds the rated winch capacity C、after a short build-up of torque D、immediately
A、add fluid that is the same color as the fluid in the reservoir B、add turbine oil because it is always a good substitute C、add any oil that has the same viscosity as the hydraulic fluid D、check the winch manufacturers instruction book
A、A.the engineers,from a panel in the engine room B、B.shutting off the current to the winch C、C.pushing the switch lever arm while the winch is running D、D.All of the above
A、that all personnel are seated in the craft B、that the cable has not jumped any grooves on the drum C、which way the wind is blowing D、the hydraulic fluid level before lifting
A、If the blue ends of the magnets are aft,and the fore-and-aft tray is at the top,you should add some magnets. B、If the blue ends of the magnets are aft you should lower the fore-and-aft tray C、If the blue ends of the magnets are aft,and the fore-and-aft tray is at the top,you should reverse the magnets D、If the blue ends of the magnets are forward,and the fore-and-aft tray is at the bottom,you should add some magnets