The technician notices that one of the wires in a CAT5 cable is cut in half. Which of the followingconnectivity issues did the technician discover?()
A、Open pairs
B、Attenuation
C、Crosstalk
D、Interference
A、Open pairs
B、Attenuation
C、Crosstalk
D、Interference
A、A. The laptop is too far away from the WAP. B、B. The WAP is using 802.11a frequencies. C、C. The laptop is only set to allow 802.11n connections. D、D. The technician is on an 802.11b network.
A、Reboot in Safe Mode B、Reboot in Recovery Console C、Reboot in Last Known Good Configuration D、Reboot in System Debug Mode
A、A. Physical B、B. Data link C、C. Network layer D、D. Transport layer E、E. Application layer
A、A. Refill the cartridges B、B. Replace the toner C、C. Replace the network cable D、D. Calibrate the inkjet printer
A、Clean the heatsink assembly of debris. B、Turn the fan off when the AC adapter is attached. C、Turn the fan to low in the BIOS. D、Replace the processor and fan.
A、The wireless switch was damaged during the display installation. B、The network card has failed. C、The new display is interfering with the wireless signal. D、The antenna connector was not reconnected.
A、Install a larger fan near the hard drive to cool the system. B、Clean the drive with compressed air and continue to use it. C、Remove and replace the drive. D、Apply more thermal compound and reseat the drive.