Which configuration command is used to make the ERX Edge Router an NTP server?()
A、A. set ntp-server
B、B. set ntp server
C、C. ntp-server enable
D、D. ntp server enable
A、A. set ntp-server
B、B. set ntp server
C、C. ntp-server enable
D、D. ntp server enable
A、Dynamic LPARs B、LPAR profiles C、Live Partition Configurability D、Multiple shared processor pools
A、Datastore Control Center B、Alarm and Trace Configuration C、Custom File Configuration D、Control Center
A、privilege-level configuration B、fabric cards C、SNMP traps D、admin- level configuration E、exec- level configuration
A、 device Discovery B、 call forwarding C、 call routing configuration D、 command line configuration E、 wireless connectivity
A、configure archive running-config B、configure replace C、copy archive running config D、copy startup-config running-config E、copy tftp running-config F、configure tftp running-config
A、A.configuring EIGRP stubs B、B.configuring a second EIGRP AS and redistributing C、C.configuring summary addresses D、D.configuring an offset-list E、E.configuring a prefix-list F、F.configuring unicast neighbors
A、You should configure Distributed File System B、You should configure SQL Server C、You should configure SQL Server Full Text D、You should configure SQL Server VSS Writer
A、Quality of Service B、Trunk configuration C、Access lists D、Routing protocol configuration E、Power over Ethernet F、DHCP configuration