A、save network cost
B、improve the reliability of supplying power to important load
C、prevent sequence reverse
D、increase the power factor of important load
更多“To （） , the power is supplied by main switchboard directly not though sub-board.”相关的问题
A、A.An additional switch for the new HMC B、B.Asynchronous adapters on the new HMC C、C.The two 570 servers are directly connected to the new HMC D、D.One 570 is directly connected to the new HMC and the other is directly connected to the existing HMC
A、The hscroot user password. B、The CE password. C、The HMC password. D、The ASM admin password.
A、The computer is unable to work in the US because of EU licensing arrangements B、The power supply needs to be replaced with one rated for 110 watts C、The power supply needs a power inverter to handle the change in cycles D、The power supply voltage needs to be switched to 110 from 220
A、The Power 550 is licensed for three LPARs only. B、There is not enough memory to meet the minimum dedicated memory requirement for the fourth LPAR. A faulty memory DIMM is detected in the POWER5 550. C、There is not enough memory to meet the minimum dedicated memory requirement for the fourth LPAR. The HMC reserves some memory toperform logical partition tasks. D、There is not enough memory to meet the minimum dedicated memory requirement for the fourth LPAR. The hypervisor reserves some memory to perform logical partition tasks.
A、The voltage selector switch on the power supply is set incorrectly. B、The 3.3v power line is connected to the wrong input on the motherboard. C、The new power supply voltage rating is too high. D、The 12v power cord is installed incorrectly.
A、The 7042-CR4 is a rack mounted model, compared to the 7042-C06, which is adesktop. B、The 7042-CR4 is limited to 16 managed systems, compared to a limit of 32 for the 7042-C06. C、The 7042-C06 has faster CPUs and twice the RAM compared to the 7042-CR4,which is suited to large enterprise deployments. D、The 7042-C06 can manage POWER5-based hardware, in addition to POWER6, while the 7042-CR4 can only manage POWER6-based hardware.
A、connect to the busbar when the load increasing B、supply power specially to charging panel C、be put into operation during the ship arriving at or leaving port D、ensure the power supply to critical equipment after the main switchboard out of power
A、The server power supply is starting to fail and causing the iSCSI NIC to intermittently lose power. B、There are too many users attempting to access the iSCSI presented disk. C、The other network traffic is causing packet delays in the iSCSI network. D、The SAN is nearing capacity and should be expanded
客服
TOP
查看正确答案
